Never had trouble with pH before, but never had to deal with RO water, either. Apparently the little bit of gravel, maybe 1/2 pound, I added as decor is the prime suspect in the jump of my pH from 6.6 to 8.4. Most of it sealed off with the silicone I used to attach it and whatever coating TopFin uses to make it shiny. You can see all of the gravel from this angle. It is a single layer siliconed onto french drain piping
The KH has gone from 6 dKH to 7 dKH, not enough to matter to me. Would so little gravel cause this shift? The only other change is the addition of plants but that should bring it down if anything, right? I can remove the gravel (substrate is EcoComplete) and redo the work with trap rock which, from what I am reading, is basalt and doesn't mess with the pH if the gravel I used is the culprit here. Your thoughts?
I have removed the decor that was covered with the offending gravel, drained 1/3 of the water (I want to keep the heaters covered, it IS winter in Minnesota, afterall) and took the following measurements:
TDS 123
KH 7
pH 8.0
The remaining water was about 80 gallons.
I added over the course of the day about 15 gallons of RO water measuring: TDS 5
KH 2
pH 6.6 The pH hasn't budged. The raw well water (filtered, not softened but Fe removed) is pretty much perfect except for the high KH, though. Is there a way to lower just the KH? TDS 209
KH 21
pH 7.2
Thank God for my hardy blue gouramis who are just going with all of this stuff and who finally recognize me as the food lady.